5.2mm ICOPAL TOP PYE PV250 SBS S5.2ww - Torch-On Top Covering Roofing Felt - 1m x 5m roll

5.2mm ICOPAL TOP PYE PV250 S5.2ww is a weldable top covering felt based on polyester non-woven fabric reinforced with glass threads, with a double-sided coating of asphalt mass: SBS modified asphalt with a mineral filler. The top side is covered with fine-grained mineral sprinkles and a strip of foil approximately 80mm wide is placed along one edge, the bottom side is profiled and protected with plastic foil. ICOPAL - TOP PYE PV250 S5.2ww felt is produced according to the patented "QUICK PROFILE" SBS technology.

• The roofing felts produced using this technology are weldable felts, modified SBS, which use a unique technology of profiling the underside, weldable side of the felt and a new generation matrix. 
• The unique way of shaping the underside of the roofing felt allows for increasing the surface of heat transfer from the burner. 
• The special thin anti-adhesive foil burns quickly, thanks to which the heat from the burner through the profile system quickly accumulates on a larger surface of the asphalt than in the case of ordinary roofing felt.
• Can achieve much better parameters in terms of breaking strength and relative extensibility.
• The thickness of the modified asphalt on the outside of the roofing felt has also been increased, which significantly extends the life of the roofing felt and increases its waterproofing and resistance to UV radiation.
• Torch applied.
• Longer service life.
• Greater durability of the roof covering.
• Complete tightness of the roofing felt coating.

APPLICATION

• Used as the top layer for single or multi-layer waterproof roof coverings, including flat roofs.

INSTALLATION

• The roofing felt should be laid at a temperature not lower than 0°C.
• The rolls must be properly prepared before laying: stored at a temperature of +15°C for at least 24 hours.
• Roofing felt should not be laid on wet roof surface, icing, during precipitation and strong wind.